JetCat

Jetcat Rx, RXI and -B Power lead 80cm Standard length.

Jetcat Smoke Pump Accessories - inlcudes stainless smoke tube and mount

Jetcat Start Gas Can

A telemetry interface for V10 ECU´s is available now (ECU software version 10.3s or higher required). The interface currently support telemetry...

Jetcat Temp Sensor for P-60 SPT series Please let us know which turbine you have so we can send the correct one.

Jetcat Temp Sensor P80-P120-P160 SE/SX Please let us know which turbine you have so we can send the correct one. Sold without nylon mount

Jetcat Temp Sensor P90-P100-P140-P-160Rxi-B, P-180Rx/NX Please let us know which turbine you have so we can send the correct one.

Jetcat V3 Kerosene starter Plug for P20-60-70-80 in SE and Older 80-160 with ECU 5.0W or higher software Includes teflon tube

New type adjustable RX version jetcat FOD Screen Call or email

One unit in stock Xmas 2022 Weight (g) 1350 Diameter (mm) 99 Length (inc. Starter) (mm 284) temperatur (°C) 490-720 Idle (1/min) 40000 Max (1/min)...

JetCat P-20 Moulded FOD SE or SX versions screen

Mounting strap for P-20 SE and SX

P-300 Pro (normal) Data connector (section) Over 15-pin SUB-D (male) there are the following control options: 1x PowerOn control signal 2x PWM input...

Special FOD for JetCat P-300 Pro

Value Pressure ratio 3,6 Mass flow (kg/s) 0,90 Consumption Full load (ml/min) 1550 Consumption idle (ml/min) 300 Weight [g] 4900 Dimensions of the...

FOD JetNet for P-100Rx-SPT-10 or P-130Rx Notched for 100 or 130N

P60 JetCat Moulded FOD screen

P90Rxi-P140Rxi-P-160Rxi-B-P-180 or P180NX-P220Rxi JetCat Moulded FOD Screen Specify Turbine 80-120-140-160-180 same P-180NX and P-220Rxi share the...

JetCat starter motor (old solder in type with bendix and O ring)

JetCat Starter motor new type P-100Rx to P-180Rxi (with mounting board)

I/O board for Rx/Rxi turbines (6 or 8 pin flat cable Not for V2-V6 ECU